A little over a week ago Moms car wouldnt start and she had it towed to Grimms Chevy to get it fixed. They determined she needed a new battery and it was working again.
She noticed her gas gauge wasnt working. We talked about it and thought it might be a fuse. DD had the fuse panel open on the car when I arrived last evening but couldnt figure out which fuse to look for because the book and the fuse diagram were too cryptic.
I decided to look on the Internets and after a quick Google on #Malibu gas gauge discovered there was a problem prevalent with them. There is a pin at 9 oclock on the gauge that the dial is supposed to rest upon when the power is off. Sometimes when the battery is disconnected and reconnected the dial jumps too far clockwise and then hangs loose at the 6 oclock position. When the key is turned on the dial needle swings clockwise and hits the pin from the bottom side, not allowing it to move to position and it looks like the gauge is reading empty.
The fix is to take a wire (we used a bent paper clip) and reach through the hole in the clear plastic around the trip odometer set button. I managed to catch the needle and spin it back around so it was setting upon the stop pin instead of being under it. Voila! Problem solved.
You will get a black page. Click your mouse anywhere (& everywhere) on the page & see what happens! Better yet, click (hold down) & drag your mouse over the black page.